HLA Attachments - 66" Brush Grapple - Hydraulic Material Handling [LA-BRG66BO500]

HLA Attachments BRG66BO500 66-Inch Brush Grapple is a hydraulic material-handling attachment configured with the BO500 quick-attach carrier for Terex TL 60, TL 65 and TL 70 loaders. Designed for brush, land-clearing debris and other awkward materials, this grapple combines a 66-inch working width with two independent grapple sections. The independent design allows each section to clamp against uneven loads, while AR400 tine tips and grapple tips provide durable contact points in demanding handling applications. A maximum 48-inch opening from the ground to the grapple point gives the attachment the capacity to engage bulky material.

Hydraulic Material Handling for Uneven Loads

The BRG66 base grapple uses independent dual grapples rather than a single full-width clamping section. Each grapple can conform to the material beneath it, helping retain irregular loads that may be higher on one side or distributed unevenly across the attachment. This configuration is particularly useful when gathering brush and handling awkward land-clearing material.

Two 2-1/2 x 8-inch hydraulic cylinders operate the grapple sections. When fully opened, the attachment measures up to 48 inches from the ground to the grapple point, providing clearance for larger or loosely arranged loads. The lower tines are spaced 5-1/2 inches apart, allowing the grapple to engage material across its 66-inch working width.

Durable Contact Points

HLA Attachments equips both the tine tips and grapple tips with AR400 material. These reinforced contact areas are positioned where the grapple engages and secures material. Combined with the independent grapple configuration, they provide a practical setup for repeated brush and material-handling work.

This model pairs the BRG66 grapple with HLA’s BO500 carrier. The BO500 is a quick-attach interface identified for compatible Terex loaders, allowing the grapple to be mounted to the supported machines listed below.

Key Features

• 66-inch working width for brush and material-handling applications
• Hydraulic brush grapple with independent dual grapple sections
• Independent grapples help clamp awkward and uneven loads
• Opens up to 48 inches from the ground to the grapple point
• AR400 material used at the tine tips and grapple tips
• 5-1/2-inch spacing between lower tines
• Two 2-1/2 x 8-inch hydraulic cylinders
• BO500 quick-attach carrier configuration
• Compatible with specified Terex TL-series loaders

Compatibility

The BO500 quick-attach carrier is intended for the following loader models:

• Terex TL 60
• Terex TL 65
• Terex TL 70

Specifications

The approximately 830 lb weight applies to the BRG66 base grapple; the manufacturer does not specify whether the BO500 carrier changes the completed attachment weight.